Little help identifing this cue

B & D Custom

AzB Silver Member
Silver Member
We got this on a trade and like it for a conversion but we're afraid to do anything to it until we know what we have. It has a weight block and a plug over it in the butt. Pretty cue, just dont' know any history on it.

Thanks for any help guys
Bob

100_1864.JPG

100_1865.JPG

100_1866.JPG

100_1868.JPG

100_1870.JPG
 
B & D Custom said:
We got this on a trade and like it for a conversion but we're afraid to do anything to it until we know what we have. It has a weight block and a plug over it in the butt. Pretty cue, just dont' know any history on it.

Thanks for any help guys
Bob

Bob it is hard to say, please take some close-up photo's of the joint, the pin, the points, and remove the bumper and take a photo of the botom of the cue.

Take care
 
B & D Custom said:
We got this on a trade and like it for a conversion but we're afraid to do anything to it until we know what we have. It has a weight block and a plug over it in the butt. Pretty cue, just dont' know any history on it.

Thanks for any help guys
Bob]

It is a cheap Taiwan built full splice from the late 80s - early 90s.

They were quite a few around here as National Billiards was an importer.

If it is still straight, it should make a reasonably good conversion. The
butt wood is Indian Rosewood, BTW.

Beyond the maple plug in the butt you will find a slug of iron
or even rebar for weight as the butts are often quite light in weight.

There is also a full length housecue version.

I call them Taiwan-ilist:) <sorry>

Dale
 
I was thinking along those line's, the joint look's to be aluminium. On the plus side it's perfectly straight and plays well.
 
I agree with Dale on this one being a Asian cue. That was maybe a $40 cue in the late 80's. The long bumper might put it a little earlier in the 80's. But it is a cheaper cue either way. Early to late 80's. IMO.
 
Back
Top