Santin23
Registered
Hello everyone,
Perhaps the following questions has been discussed before, but I haven’t found any solid answer so far….
Do you know if I can pair a longoni 3-cushion shaft w/VP-2 joint with a Longoni pool cue butt??? Does it fit properly???
I know there are slightly differences between both designs, due to the specs for each discipline. Actually, I read in Longoni’s website that technical specs and the joint collars are different even for less than .5 mm. On the other hand I asked directly to Niels Feijen and he said they are compatible, so I’m confused now.
Thanks in advance!
Perhaps the following questions has been discussed before, but I haven’t found any solid answer so far….
Do you know if I can pair a longoni 3-cushion shaft w/VP-2 joint with a Longoni pool cue butt??? Does it fit properly???
I know there are slightly differences between both designs, due to the specs for each discipline. Actually, I read in Longoni’s website that technical specs and the joint collars are different even for less than .5 mm. On the other hand I asked directly to Niels Feijen and he said they are compatible, so I’m confused now.
Thanks in advance!