Macassar Ebony and B-eye Maple w/ 2 shafts

Jim Baxter

AzB Gold Member
Gold Member
Silver Member
This cue just finished . Came out Beautiful . I took it to a Mermorial service yesterday , pool tournament at Eagals , hit a few ball , Great shooter . 19 1/2 inch balance point . 18.6 oz, with a 1/2 oz weight in butt . Shaft a nice 4.2 with no brass bushing . Everyone talks about there Schon shaft weighing 4.6 ozs, but they have a .5 oz. brass bushing they forget to mention . Butt is 14.3 oz. . Shaft a nice shooting 13.2mm which can be taken down , would be able to grow bigger , but I don't have that much time left , will be 70 next month . The ferrel is a hard Ivorine 4 and the tip is a Kamui M black . Hard ferrel soft tip works everytime . Cue is standard 58" long . Take special interest in the long points and not how sharp they are at the bottom . The blank for this cue was built by a old time cue maker in Seattle , Ernest Omori . A perfectionist , and his newer blanks are even sharper at the bottom . Check out the test section he has several threads there with his blanks . This quite long so I will post some pictures .

Asking $ .... SOLD..... . shipped for cue and J/ps . I have 2ed shaft almost done . Low deflection 30" long . 59" butt 30" 2end shaft . No price change .
I took it out side for better light .







 
Last edited:
Shaft still being worked on , but it will be a shooter LD with black soft Kamui . JIm
 
Awesome cues

Jim make some awesome cues, you know if i could make up my mind, I would buy it immediately ! Good luck , buyer will be so satisfied
 
Back
Top