MC2

[j2pac]

Not sure if this the right forum or not. Here goes.
An old friend of mine is looking to get in touch with Jim Babcock, aka...MC2, regarding some equipment.
Is anyone here still in touch with Jim?
My thanks in advance for any info.
Best regards.
Joe P

 

[JerseyBill]

Not sure if this the right forum or not. Here goes.
An old friend of mine is looking to get in touch with Jim Babcock, aka...MC2, regarding some equipment.
Is anyone here still in touch with Jim?
My thanks in advance for any info.
Best regards.
Joe P

I haven't been on for a long time, but Jim did come in this sight often when I was frequenting it. So answer is I have no answer, if you get in touch tell him Bill said hi and asked about him.

 

[j2pac]

I haven't been on for a long time, but Jim did come in this sight often when I was frequenting it. So answer is I have no answer, if you get in touch tell him Bill said hi and asked about him.

Will do.

 

[JerseyBill]

I haven't been on for a long time, but Jim did come in this sight often when I was frequenting it. So answer is I have no answer, if you get in touch tell him Bill said hi and asked about him.

jamesbabcock@frontier.com old email address

 

[JoeyInCali]

Hoping everything is ok at Jim's end.
He's been a ton of help for cnc'rs .

 

[j2pac]

jamesbabcock@frontier.com old email address

Thank you! I will try to reach out to him.

 

[Dave38]

Well, I know that Atlas no longer advertises or lists his fixtures on their site. Maybe a phone call to them may give you a way to contact him.....or atleast an update on him

 

[j2pac]

Well, I know that Atlas no longer advertises or lists his fixtures on their site. Maybe a phone call to them may give you a way to contact him.....or atleast an update on him

Thank you for the suggestion.

 

[SpiderWeb]

He bet cash that trumph would win, so maybe he is ducking.

 

[JerseyBill]

Hoping everything is ok at Jim's end.
He's been a ton of help for cnc'rs .

yes , he was a really helpful guy, went way out of his way to help me.