Mezz HP2 will not fit on Tasc?

[mel_smOg]

Hey, I just got Mezz shaft for united joint and it does not fit any of my cues. I am pretty upset as I wanted to try that shaft for sooooo long. I had 2 other Mezz shafts WD700, and first generation Hybrid both for united joint and they were fine on all my 5/16x14 cues

anything I can do?

there is the picture at the point when I cannot screw it anymore, so about half of pin

 

[vinnyfromparis]

you should order a mezz shaft with a 5/16x14 and not the united joint.......

 

[mel_smOg]

you should order a mezz shaft with a 5/16x14 and not the united joint.......

but both other shafts WD700 and Alpha hybrid were for united joint and fitted it nice. i guess I should sell it now

 

[$TAKE HOR$E]

A decent cue guy could make that shaft fit no problem

 

[Ken_4fun]

I know better but I will ask....


WHY ?!?!?!?!?

Ken

 

[mel_smOg]

I know better but I will ask....


WHY ?!?!?!?!?

Ken

I just cannot play with 13mm shaft with ivory ferrules that deflect like crazy, so used to LD shafts and Mezz shaft (Alpha Hybrid) on tascarella is just something out of this world- any other shaft felt like garbage

I will go to local cuemaker and I think he will help me out, thanks Stake horse

 

[scsuxci]

Hey buddy,I've had a few Mezz shafts that did the same.The threads might have
to be widened as the shaft slots aren't aligning with the pin threads the farther down
you tighten it.Goodluck