My latest pickup... Nope... It is not a cue...

[Guerra Cues]

Hey folks,
So, I met somebody a few weeks ago and went to this new friend shop, besides him having an unreal wood supply and dust collecting setup, I picked this baby up... Enco 110-1340. If anybody could help me out locate a manual or point me in the right direction I would appreciate that...
When he sent me pictures I thought I would be in a worst shape, but when I saw it it was in very, very good condition... Quite a bit of tooling as well and another 4 jaw chuck...

 

[pescadoman]

http://www.use-enco.com/cgi/inpage?pmpage=machinery/manuals.htm

 

[Guerra Cues]

http://www.use-enco.com/cgi/inpage?pmpage=machinery/manuals.htm

Thanks Randy but I did not see the 110-1340. I think that the 110-1351 might do the trick, not sure.

 

[pescadoman]

I thought it was there. I spoke to Aaron about this lathe and sounded like a nice fellow. I just didn't have enough time to get that and the one I picked up, then dropped(literally) in San Mateo. Give me a sec and I'll find something, as I researched that lathe.

 

[pescadoman]

Hmm... I thought I had found the manual. Here is a link to someone who has the same lathe and it appears the 1151 is close to the same lathe. Maybe he can make a copy for you. It is also possible Enco has a copy of the manual, but not as a download..

http://www.chaski.org/homemachinist...ghlight=&sid=54182972fccf47bf8d02ef5a3307b97c

 

[Guerra Cues]

I thought it was there. I spoke to Aaron about this lathe and sounded like a nice fellow. I just didn't have enough time to get that and the one I picked up, then dropped(literally) in San Mateo. Give me a sec and I'll find something, as I researched that lathe.

You were the one :thumbup: Yep, the lathe sounds really good and looked better than expected.

 

[JoeyInCali]

Real men don't read manuals.
Pfft!

 

[Guerra Cues]

Real men don't read manuals.
Pfft!

I hear you Joey. I know I have a good learning curve my friend.

 

[JoeyInCali]

I hear you Joey. I know I have a good learning curve my friend.

Just kidding.
See that big red X next to the chuck back plate?
Don't change gear while the lathe is turning .
It's not a car.:grin:

 

[63Kcode]

Nice find!

Larry

 

[cuemaker03]

I am sure you felt the differnce the first time you turned the handwheels. Congrats.