Need to get a new shaft made using the same collar

kingman33

kingman33

AzB Silver Member
Silver Member
I’m looking for a new shaft to replace a unique matching collar. My question is, could the collar from the original shaft still be used to make a new shaft? Who makes the best custom shafts on the market? Thank you
 
kingman33 said:
I’m looking for a new shaft to replace a unique matching collar. My question is, could the collar from the original shaft still be used to make a new shaft? Who makes the best custom shafts on the market? Thank you
Click to expand...
The answer to your first question is.
Yes, it can be used.
The second question???

Did you ever see Snow White.
Mirror Mirror on the wall.
Who's the farest of them all.

About sums it up.
Hahahahahaha
 
Michael Webb said:
The answer to your first question is.
Yes, it can be used.
The second question???

Did you ever see Snow White.
Mirror Mirror on the wall.
Who's the farest of them all.

About sums it up.
Hahahahahaha
Click to expand...
I understand, so many shaft makers in the market, thanks for the response
 
I can move the entire collar and threaded section to a new shaft........ I have done many......... you can never tell is was done.

Kim
 
whammo57 said:
I can move the entire collar and threaded section to a new shaft........ I have done many......... you can never tell is was done.

Kim
Click to expand...

This.

The first shaft I made was for a Huebler that had a badly warped shaft. Removed the ring and put it on the new shaft and it looks factory (still needs a finish though).
 
whammo57 said:
I can move the entire collar and threaded section to a new shaft........ I have done many......... you can never tell is was done.

Kim
Click to expand...
Can you take the collar and piloted section off a 5-16/14 compression joint and put it on a new shaft?

If so, how much?
 
Last edited:
You must log in or register to reply here.
Back
Top