Purchased a TSP&B repair lathe a few years ago and through trial and error learned to install tips, ferrule, etc., on a very high quality level. Observed a lot of installs at shows/tournaments when I wasn't playing and asked lots of questions of very cooperative and secure in their abilities professionals... thanks Joe Blackburn et al.
Todd's lathe is excellent and I have never had a problem with it. Just had a desire to acquire a Porper which seemed to be the popular choice of those observed. Finally, got the chance to purchase a used one in great shape with most original accessories ( e.g., Collets, centers, router, foot control, linen holder, etc.) at a very fair price.
Only significant issue I could find is shown in one the attached pics showing significant pitting just behind the chuck. This machine sat for sometime and was used only a few times. Can't figure how this happened as this compartment is covered. Really interested how to correctly clean it up, if possible, without damaging motor components. Was going to use steel wool with wd40 but concerned that metal flakes could get into motor components.
Any suggestions would be appreciated.
Not going to build cues. Sneaky pete at best. Have too much appreciation for the lifetime knowledge base required. Had two and a half careers, not looking a another. Lathe came with two Hightower and three Churchill VHS tapes and instructional Porper. Always looking to learn. Unfortunately all but the Porper are shot... audio gone and video ragged. With all do respect to Joe for his creative abilities, his instructional tape covered too much, too generally, lacking coherent set up and basic info for a Porper novice. Following a lead here on AZ, Ryan is sending me a newer DVD.
Very pleased with this purchase and hope to do it justice as I learn its secrets and potential.
Todd's lathe is excellent and I have never had a problem with it. Just had a desire to acquire a Porper which seemed to be the popular choice of those observed. Finally, got the chance to purchase a used one in great shape with most original accessories ( e.g., Collets, centers, router, foot control, linen holder, etc.) at a very fair price.
Only significant issue I could find is shown in one the attached pics showing significant pitting just behind the chuck. This machine sat for sometime and was used only a few times. Can't figure how this happened as this compartment is covered. Really interested how to correctly clean it up, if possible, without damaging motor components. Was going to use steel wool with wd40 but concerned that metal flakes could get into motor components.
Any suggestions would be appreciated.
Not going to build cues. Sneaky pete at best. Have too much appreciation for the lifetime knowledge base required. Had two and a half careers, not looking a another. Lathe came with two Hightower and three Churchill VHS tapes and instructional Porper. Always looking to learn. Unfortunately all but the Porper are shot... audio gone and video ragged. With all do respect to Joe for his creative abilities, his instructional tape covered too much, too generally, lacking coherent set up and basic info for a Porper novice. Following a lead here on AZ, Ryan is sending me a newer DVD.
Very pleased with this purchase and hope to do it justice as I learn its secrets and potential.
