> Has anyone else seen this new variation on the Radial pin? It's a 5/16-10,quite a bit longer than the standard Radial,but I'm assuming its intended use is in piloted joints,thus the smaller OD/higher TPI. So far,I've only seen it on PFD cues,using a short piloted ivory joint,still screwing into wood but there is a lot more wood in that end of the joint now with the smaller bored/threaded hole. Also,has anyone tried the Supra pins? I've been reading about these on Chester Krick's site,and they look interesting,gotta love a black anodized pin,since black G10 is nowhere to be found,according to Cue Components. Tommy D.
