No weight bolt ?
- Thread starter measureman
- Start date
That bore is for the bumper.
As I told you in the other thread with the exact same question, they vary dimensions to hit target weights.
I ordered a 60" sneaky from them some years back, and did not know this. The plan was to use Predator 314 shafts I already had. When the cue showed up, the joint was .870-.880 if memory serves (standard for a 3/8 10 should be .850), and the butt diameter was way oversized as well, cant remember the exact measurement, but was very noticeable in the hand.
I then asked about supplying measurement specifications, and they said no problem. So I have gone that way since. I have 5-6 customs from them.
I called them and got the answer at that time (2015ish?). I gave you the answer that Dave Schmelke gave me.
The cue with the wonky dimensions is on top in this picture. I ended up using a stinger shaft on it as a break cue for a while.
I had to order another cue (butt only) from them with my specs, so the LD shafts I already had would fit it. Both together was still well under $300. :thumbup:
I had to order another cue (butt only) from them with my specs, so the LD shafts I already had would fit it. Both together was still well under $300. :thumbup: