Porter Cable 7301 router FS

Dave38

Dave38

theemperorhasnoclotheson
Silver Member
I have upgraded to fullsize router motors on my lathes and have no more use for the small one. I have replaced the bearings on this about 4 months ago, the brushes are in excellent shape and I cleaned the whole housing etc. I did remove the spindle lock pin and made a pin that I insert when changing the bits. I found this to be better than trying to press a button and turn a wrench at the same time. I am including the pin, and the stock wrench that came with it.
$55 shipped to the 50 states. First to post here gets it. Thanks,
DAve
DSCN1035.jpg
 
me me me me

dont bother with the pin & the wrench dave

i take 'em out too

pm sent with ship info and will paypal you later tonite
thanks dave!!!
 
Last edited:
hey dave, have you mailed router yet?

i forgot all about it

did you too?? LOL
 
BHQ said:
hey dave, have you mailed router yet?

i forgot all about it

did you too?? LOL
Click to expand...

I didn't forget you Brent, I was busy this weekend celebrating my birthday..:cool:. lol. I dropped it at the post office on Tuesday, tracking says it'll be there this Monday. Sorry for the delay. Tracking number is 9461209699939041579600
Dave
 
Dave38 said:
I didn't forget you Brent, I was busy this weekend celebrating my birthday..:cool:. lol. I dropped it at the post office on Tuesday, tracking says it'll be there this Monday. Sorry for the delay. Tracking number is 9461209699939041579600
Dave
Click to expand...
no worries matie
i reallly did forget all about it until cruising this section today :embarrassed2:
 
You must log in or register to reply here.
Back
Top