Rear Chuck Question

I have one on my Enco. I used it for joint work until I bought my Jet that I have now. I have rear chucks on both. Give me a call it would be easier to explain rather than typing.

Thanks:
DOUG
 
Joint Work

zx24 said:
Would this Enco lathe be a good cue lathe for joint work? If So, how would I go about installing a rear chuck? Any help and ideas would be appreciated...

http://www.use-enco.com/CGI/INSRIT?PMAKA=510-2585&PMPXNO=9033435&PARTPG=INLMK3
Click to expand...

Hi,

If you are going to use it for joint work only here is a small benchtop model with a 1.5" spindle bore. Put a rear chuck on and you will be ready to go.

http://www.boltonhardware.com/categ...etal-lathes/12-x-24-gear-head-bench-lathe.php

Rick
 
scdiveteam said:
Hi,

If you are going to use it for joint work only here is a small benchtop model with a 1.5" spindle bore. Put a rear chuck on and you will be ready to go.

http://www.boltonhardware.com/categ...etal-lathes/12-x-24-gear-head-bench-lathe.php

Rick
Click to expand...

I just purchased the 13 x 40 enco....I have been looking at the 12 x 24 bolton lathe also..I'm prolly going to go ahead and pick one of those up while its on sale just to have one..I like the large spindle bore....
 
You must log in or register to reply here.
Back
Top