Reselling cue

chuckpilegis

AzB Silver Member
Silver Member
Just got this cue in yesterday from RDCustomcues.
Had him put a leather wrap on it
Unfortunately I wasnt paying attention and thought that this had a piloted
stainless steel joint.
I was going to use it with my various aftermarket shafts.
Probably cost too much to convert so I am selling
Butt is 15.4 oz 5/16x14 flat faced
Matching shaft is 4.0 oz Plain black collar is 4.2 oz at 13mm each

Selling for 250 shipped with the matching shaft plus 50 if you want the other one
b72e8d3b.jpg

4816c06e.jpg

3465866d.jpg

da5aeaf0.jpg
 
Last edited:
NJ_Qball said:
Looks just like the jacoby you bought from me a while back, with the obvious exceptions!
I was going to sell that one when this came in because I like a leather wrap
 
dave sutton said:
Wouldnt Me Too Much To Convert. Maybe 25$ Or So. New Pin With A Bore. Easy Job
too bad you couldn't take it on.... and do the leather wrap as well. I hear you have them down better than Hercek himself... true?
 
cowboyup200560 said:
are both the shafts actuall Jacoby shafts??? I am interested
Well the one with matching rings is.
I will pm RDCustomCues to find out where the other came from.
Also have couple black collar shafts that are jacobys for sure
Would need the pilots removed to fit this cue.......Chuck
 
Back
Top