McDermott D-15
$400 plus shipping method of buyer's choice...
Specs:
- 4 Cocobolo points with black/green/orange veneers on birdseye maple with Cocobolo butt sleeve (small dot of discoloration in the butt sleeve -- about 1/16 of an inch -- under the finish. Will do my best to show in pictures when I get them up).
- Ivory colored butt cap and joint collar (very small chip at top of joint collar and little bit of chipping at very bottom edge of butt cap -- none of which affects play, of course).
- White w/ green speck wrap (new from McDermott Factory -- hasn't been played with for more than an hour since it was done).
- Ringwork on position A/B/D/E (everywhere but at the base of the points).
- 3/8x10 joint pin.
- 19oz.
- Around 12.5mm shaft (Brand new LBM ferrule and Triangle tip just put on by Mike Gulyassy, and resealed the shaft -- slickest, smoothest shaft I've ever felt, honestly!).
Cue cost me a little over $350 at time of purchase, and the new ferrule/tip by Mike costs me $50, so I'm just trying to get out of the cue what I put into it, more or less...
Need monies to recooperate from Christmas and support my first trip to the Derby City Classic! Also want to buy a second shaft for my new Nitti from Chris...
Help me.
(NOTE: I could not get a good picture of the chip in the butt sleeve -- but I'm pretty sure most of you know what it would look like...its that typical small "flake" chip-off of the top. Also, I took a picture of the butt sleeve with flash to note the detail, so keep in mind the colors are off in that pic. Thanks!)
Again, tried to work with what AZ allows (100kb or less), but if for whatever reason, someone would like to see some bigger pics, PM me with your email address and I'll send 'em right over.
$400 plus shipping method of buyer's choice...
Specs:
- 4 Cocobolo points with black/green/orange veneers on birdseye maple with Cocobolo butt sleeve (small dot of discoloration in the butt sleeve -- about 1/16 of an inch -- under the finish. Will do my best to show in pictures when I get them up).
- Ivory colored butt cap and joint collar (very small chip at top of joint collar and little bit of chipping at very bottom edge of butt cap -- none of which affects play, of course).
- White w/ green speck wrap (new from McDermott Factory -- hasn't been played with for more than an hour since it was done).
- Ringwork on position A/B/D/E (everywhere but at the base of the points).
- 3/8x10 joint pin.
- 19oz.
- Around 12.5mm shaft (Brand new LBM ferrule and Triangle tip just put on by Mike Gulyassy, and resealed the shaft -- slickest, smoothest shaft I've ever felt, honestly!).
Cue cost me a little over $350 at time of purchase, and the new ferrule/tip by Mike costs me $50, so I'm just trying to get out of the cue what I put into it, more or less...
Need monies to recooperate from Christmas and support my first trip to the Derby City Classic! Also want to buy a second shaft for my new Nitti from Chris...
Help me.
(NOTE: I could not get a good picture of the chip in the butt sleeve -- but I'm pretty sure most of you know what it would look like...its that typical small "flake" chip-off of the top. Also, I took a picture of the butt sleeve with flash to note the detail, so keep in mind the colors are off in that pic. Thanks!)
Again, tried to work with what AZ allows (100kb or less), but if for whatever reason, someone would like to see some bigger pics, PM me with your email address and I'll send 'em right over.
Last edited:
