shaft

[sciarco]

I have a 3/8x10 OB2 11.75mm will it fit a .850 3/8x10 diameter joint thanks.

 

[asbani]

if the diameter of the shaft where it screws is .850 then yes, but if you're asking about the default made, they usually make a .840 shafts as default unless requested, so if this is true then it would mean that the shaft will be a tad thinner than the butt and you would feel a slight edge from the butt when they're screwed together. hope this helps.

 

[RBC]

All stock standard OB shafts with the 3/8-10 joint are made to .850" diameter.


Royce

 

[asbani]

I'm sorry then, I must be mistaken with the OB, Royce knows better for sure.

I was speaking in general, I thought most shafts were made by default as .840 - I know mezz are for sure.