Shafts Picture

[brianna187]

End View Of Our Shafts We Have Over 1000 Shafts And More Coming On A Regular Basis Now We Will Have A Very Large Selection Of The Folowing At Valley Forge..... Shaft Dowels, First Tapper Shafts, Birds Eye, Curly, Pre Made Handles, Cored Ebony, Cored Birds Eye , Delrin Butt Size 1 Ft Pieces White,pre-made Veneers For Points 3 Sray Booths Ready To Go 15 Leather Wrap Fixtures, Are New Tappered Stainless Steel Joints ,3/8-11 Brass Pins 3/8-10 X4" Pins Leather Wrap Templetes,also Lizard Skins And Lots Of New Leather Wraps, See You All There

 

[nympfisher]

Thanks Lee for the shafts, i finished 1 this evening . installed ring off old huebler shaft and even made a nylon insert. fits pretty good and tightens like a huebler too. hope to get to try it tomorrow.

Carl Shealy

 

[brianna187]

we are working every day on new shafts call us for an order...lee
517 639 3190

 

[BLACKHEARTCUES]

Thanks Lee for the shafts, i finished 1 this evening . installed ring off old huebler shaft and even made a nylon insert. fits pretty good and tightens like a huebler too. hope to get to try it tomorrow.

Carl Shealy

Hi Carl; what was the joint diameter of this shaft, when you got it?...JER

 

[nympfisher]

i will recheck this evening, i didnt have to remove much to get it to the diameter of the old joint collar. .015 i think,all by sanding from 280 to 1000. but will check , i wrote it down.
carl

btw i used the sanding conditioner i recived from you, it seemed to help keep the paper from clogging as well as smother finish, i also assumed you are supposed to use it between grits too,

STARTED OUT AT .870 FINISHED AT .832 , TIP WAS 13.4 MM FINISHED 12.9(WANTED 13)

 

[nympfisher]

Here Are Pics

this is my first try , edges a little rough on wrap(need to sharpen grove ends a little more i think.

carl

 

[Carter]

Shafts

Lee,

thanks again for the shaft dowels......Great growth ring count.

 

[brianna187]

thanks chad
chads a great cuemaker and a gentleman do miss out on one of his super playing cues.........

 

[Craig Fales]

this is my first try , edges a little rough on wrap(need to sharpen grove ends a little more i think.

carl

Could you post some closer and larger pics???