Custom linear worm gear & water cooled spindle motor lathe setup. I put this together to eliminate the need for a router motor on my taper bar and lathe for shaft and butt taper work. It runs on an inverter that is included. 220 in 220 3 phase out. All wired. Have book and illustrations Worm gear runs on 12 volt rheostat variable speed. Has 4 collets. Stop switches. It is a one off innovation to solve a specific application. The lathe is not included. The slide and compound could be adapted to stepper motors as well. Extra hardware and plates included. Need 450.00 for the package. You pay ground freight.









