Straight or 15 degree lead angle turning tool?

Rip

Rip

AzB Silver Member
Silver Member
I usually use the blade in hand method for tip/ferrules but would appreciate advice regarding cutting bits.
Atlas offers C6 grade carbide tipped bits 3/8" shank Right Straight Turning Tool (AR6) and the same bit with 15 degree lead angle (BR6).

When facing a ferrule and trimming sidewall of tips close to flush with ferrule before finishing with sandpaper, which of these two bits are preferred and why?

All input will be appreciated.
 
My personal opinion............. it doesn't really matter....... what matters is that you are familiar with your tools and know how they work and cut.

Don't try to over think it.........

Kim
 
I can also verify these cutters RULE,plus that is as good a price on them as you will probably find.

These are about the only brand I've found that are good enough to do tips and ferrules right out of the box.

Sometimes,the factory tip radius on carbide lathe tools doesn't add up to a acceptable job on leather and ferrule materials,meaning they usually need to be sharpened.

The Micros don't have this problem. Tommy D.
 
whammo57 said:
My personal opinion............. it doesn't really matter....... what matters is that you are familiar with your tools and know how they work and cut.

Don't try to over think it.........

Kim
Click to expand...
Thank you Kim. Sounds like good advice.
 
JoeyInCali said:
Don't use a turning bit for trimming the tip.
Use a parting tool then razor blade when you get close .

http://www.ebay.com/itm/MICRO-100-A...951905?hash=item33ae9e7361:g:nRUAAOSwNyFWdWiP
That for the ferrule .
It's a workhorse. Micro 100 is like the Freud of lathe tools. Their carbide is tops. You can even hand sharpen them later with a diamond sharper ( 600 grit and up ).
Click to expand...
Joey, TommyD,
I just ordered a couple of the Micro 100.
Thank you both for your suggestion.
 
You must log in or register to reply here.
Back
Top