TAD Ring work stock

[NYCueCollector]

I am looking for some Tad Ring work stock. I beleive it has 20 windows maple and Black.

I am looking for enough to do about 6 shafts.

Let me know if you have some or the best place to get some.

 

[rhncue]

I am looking for some Tad Ring work stock. I beleive it has 20 windows maple and Black.

I am looking for enough to do about 6 shafts.

Let me know if you have some or the best place to get some.

The best place, of coarse, is to make some in your shop but if you don't have these capabilities you can always call Prather at:

http://www.prathercue.com

They will make any configuration of deco-rings that you desire.

Dick

 

[Varney Cues]

Check with Dave Sutton. He was making some Tad-ish cues and may have some billet already built.:wink:

 

[dave sutton]

I dont have the maple joint dashes like tad. Prather can make it up or lee at brianna might already have some in stock

I USED SILVER RINGS AND 14 PIN SO MY CUES COULDNT BE MISTAKEN FOR TADS

 

[Varney Cues]

MY CUES COULDNT BE MISTAKEN FOR TADS

I thought I'd seen a Tad tribute cue you'd made where the butt sleeve looked like a Tad?

 

[dave sutton]

I thought I'd seen a Tad tribute cue you'd made where the butt sleeve looked like a Tad?

he wants shaft ringwork not buttsleeve

he wants this...

not this...

 

[Varney Cues]

You are right Dave...sorry but I wasn't even thinking he needed the joint billet instead of butt size. I need to read slower.:embarrassed2:
I did remember you though with the Tad looking butts. What he wants is pretty easy. I learned a trick from a world famous cuemaker with over 18yrs of cue building experience...all you need is some maple rings and a black Sharpie.:thumbup:

 

[KJ Cues]

I am looking for some Tad Ring work stock. I beleive it has 20 windows maple and Black.

I am looking for enough to do about 6 shafts.

Let me know if you have some or the best place to get some.

It's a simple enough billet to build.
I could build the billet for you or build it and cut the rings from it that you need. Hell, I may even have that billet in stock.
In any event, whether you want just the rings or the billet itself, I'd need exact dimensions.

PS. 18 dashes makes more sense. You may want to count them.

 

[Jim Baxter]

Ring work

I am looking for some Tad Ring work stock. I beleive it has 20 windows maple and Black.

I am looking for enough to do about 6 shafts.

Let me know if you have some or the best place to get some.

Hi I have been makeing my own 18 and 20 , I'll look to see what I have left over. What ring thickness you looking for. or do you want the billit and cut your own .?? Look in my j/p gallery and see what I've been makeing. jim