Taper Shaper At Work.....

[FLYINGSNAIL]

TEST CUT FEW SHAFTS AND .857 AT JOINT AND AT TIP .521 FOR 30" SHAFT WOOD.
P.S. YES , I JUST MADE THAT BOX MY SELF TO ENCLOSED THE TAPER SHAPER...

 

[CueCaps]

Show Cased

Hey Ken,
Looks like it's on display at a Trade Show.
What a clean set-up..
It shows your attention to detail..

(Joey's Reply Post below: I think ATF is Automotive Transmission Fluid)

 

[JoeyInCali]

Put a stopper on that taper bar by the driver end.
That way if you move the bar, all you have to worry is the other end.
I caliper the distance from the bar's outside line to the tailtock mount.
Like 4.400" for forearm, 4.350" for shafts and 4.370" for straight cuts ( using the inside line of the bar for guide for straight cuts).
I use ATF oil to keep the grooves and rods smooth.

 

[cuemaker03]

Looks nice!!!