Thanks to n10spool (Craig) and Shane!!

P

pip9ball

AzB Silver Member
Silver Member
Hi,

I just wanted to extend my thanks to Craig and Shane for having the patience and diligence while setting up my Diamond table.

RKC will agree that my slates are a big pain in the rear to level out due to some crowning of the middle section. It took the better part of 4-5 hours chasing the bubble round and round until all the tweaks were worked out.

They didn't finish up until about 2:00 AM and I haven't had time to post the final pictures but will do so when I get off of work today.

Again, thank you sirs!

-Phillip
 
pip9ball said:
Hi,

I just wanted to extend my thanks to Craig and Shane for having the patience and diligence while setting up my Diamond table.

RKC will agree that my slates are a big pain in the rear to level out due to some crowning of the middle section. It took the better part of 4-5 hours chasing the bubble round and round until all the tweaks were worked out.

They didn't finish up until about 2:00 AM and I haven't had time to post the final pictures but will do so when I get off of work today.

Again, thank you sirs!

-Phillip
Click to expand...
They had kind of a hard act to follow;) glad to see they got it done, and done right:D

Glen
 
realkingcobra said:
They had kind of a hard act to follow;) glad to see they got it done, and done right:D

Glen
Click to expand...

Hi Glen,

Yes this is true....time for me to upgrade and swap with a nice diamond pro-am. Let me know if you can work a deal on one.

-Phillip
 
Thanks for the kind words everyone. This table was a real challenge but I guess you can say I beat the ghost on this table.

The table plays great and if he wants to sell it I will put it in my house anytime.


Craig Herman
 
table work

Hey Craig, The corner pockets look real clean. I can tell the Cobra has worked with you.Keep up the good work.
Ron
 
You must log in or register to reply here.
Back
Top