Has anyone done or seen this config work (less cutting, simpler approach and keep the polisher cooler)?
Items:
Items:
- 5 gallon new / clean bucket
- 10" replacement orbiter drive pad:
- WEN 10" orbital polisher with extra pads:
- 8" x 11" gray felt with adhesive backing, cut to strips to line bucket to match ball rotation path (leftover from another project)
- an old towel and maybe a dumbbell or similar weight
- bucket on firm ground
- weight then folded towel placed at bottom of bucket
- drive pad with extra polishing pad over goes soft side up on top of towel
- measure and cut felt for balls and line bucket with felt, add ball set to bucket after felt installed
- setup WEN polisher with polishing pad, apply some aramith ball polish (on pad or balls individually?)
- insert WEN polisher pad side down, turn on polisher and monitor progress