WTB: Shaft Spinner

T

the9ballroller

AzB Silver Member
Silver Member
I know its a longshot, but I would like to buy a device that just spins shafts for cleaning and perhaps trimming tips. I do not want to spend over 200 dollars cash, but I even have a couple cues I could throw in for trade if you have something higher priced in mind. I have arbors for different sized joint pins, just need some sort of premade device with a motor and a variable speed that canhold the shaft while it spins. Not seen too much on eBay that appealed to me.

Thanks,
Roller
 
the9ballroller said:
I know its a longshot, but I would like to buy a device that just spins shafts for cleaning and perhaps trimming tips. I do not want to spend over 200 dollars cash, but I even have a couple cues I could throw in for trade if you have something higher priced in mind. I have arbors for different sized joint pins, just need some sort of premade device with a motor and a variable speed that canhold the shaft while it spins. Not seen too much on eBay that appealed to me.

Thanks,
Roller
Click to expand...

wouldn't a drill work? Know I've seen some setups like that with some rollers made up. Search around and you'll find some directions.
 
You can make one for about $10 or less. Get a rubber crutch tip. Drill a hole in the center of the bottom. Put a washer on the inside and the outside and put a 1" x 1/4" bolt through the hole with a nut on the outside. Put the bolt in a drill and a shaft in the part of the crutch tip where the crutch goes and there you have it. I"ve had one for a few years and have cleaned many shafts and replaced a bunch of tips with it.

Try a search for crutch tip.
 
Last edited:
You must log in or register to reply here.
Back
Top