first off let me say i can make one of these myself. but i live in the middle of nowhere so it would cost more in gas to make it worth while. anyway, i need a piece of brass or steel (or any other metal) made into a sleeve. one inch in length, ID-14mm, OD-dont care. its going to be used to compress tips without them squishing out and increasing diameter. the one i am currently using is 1 inch segment of an old POS cue i had. cut a piece off, drilled a hole through it and use 2 14mm pieces of phenolic to press a tip in a vice. well, the hard rock maple i was using has seen its better days. if someone could make one for me that would be great...thanks,
Jay