90 degree cutter

[winners07]

who sells the larger 90 degree cutter i have the 5/8 but i want the 3/4 one, i know that grizzly sells the smaller one but cant find the larger one. ive always plunged in at a 45 but want to try this one, thanks gary

 

[winners07]

router bits

who sells the larger 90 degree cutter i have the 5/8 but i want the 3/4 one, i know that grizzly sells the smaller one but cant find the larger one. ive always plunged in at a 45 but want to try this one, thanks gary

I found one at unique products thanks anyway gary :thumbup:

 

[josie]

I got one at moon cutter company. They are very helpful too.

 

[cueman]

I sell the carbide one inch for $55.

 

[snipershot]

I bought one from Chris, and it looks pretty beefy. I haven't used it yet, but I like how it looks.

Joe

 

[whammo57]

cutter

PM sent

Kim

 

[rhncue]

I sell the carbide one inch for $55.

Chris, I just visited your site to get some information on this one inch cutter. The drawing confirmed that the cutter cut from the side but I have one more question which is: what size stem is on the one inch V cutter, 1/4", 1/2" or other?
Thanks,

Dick

 

[Jaden]

Is that one a half inch collet???

I sell the carbide one inch for $55.

Does that one have a half inch shaft or a quarter???

Jaden

 

[cueman]

It is 1/4" shank.

 

[josie]

I got one at moon cutter company. They are very helpful too.

I should clarify the one I mentioned is a 7/8" shank used in my mill with a 7/8" r-8 collet. I assumed you were using a mill since you said you had been working off a 45 degree plunge cut.

 

[winners07]

cutter

I should clarify the one I mentioned is a 7/8" shank used in my mill with a 7/8" r-8 collet. I assumed you were using a mill since you said you had been working off a 45 degree plunge cut.

no im sorry for the confusion i ment router bit. i have my router mounted at a 45 but was looking for a larger 90 cutter that 5/8 but i have found one so thanks again gary