How do you polish out a Stainless Steel Joint?

GBCues

GBCues

Damn, still .002 TIR!
Gold Member
Silver Member
I've got a cue in for a linen re-wrap - no problem there. But there are "smudges" on the stainless joint - they are not scratches, more like rub marks.

How do you guys suggest polishing them out?

Thanks in advance,

Gary
 
GBCues said:
I've got a cue in for a linen re-wrap - no problem there. But there are "smudges" on the stainless joint - they are not scratches, more like rub marks.

How do you guys suggest polishing them out?

Thanks in advance,

Gary
Click to expand...



Hey Gary, if they are not scratches use a cloth and a polishing compond while the cue is spinning in my lathe. I normally use the same polish I use for the cues finish which is Meguiars Mirror Glaze 205 it works great and it will not harm the finish.

Hope this helps
 
All the previous are excellent suggestions. I finish with a soft cloth and jewelers rouge.
 
Let me throw a new one out there for kicks. Turtle wax spray lubricant and Headlight restorer.
 
manwon said:
Hey Gary, if they are not scratches use a cloth and a polishing compond while the cue is spinning in my lathe. I normally use the same polish I use for the cues finish which is Meguiars Mirror Glaze 205 it works great and it will not harm the finish.

Hope this helps
Click to expand...

Craig,

This was my original thought too and it worked well - no more rubmarks!:smile:

But I thought I'd ask first to make sure I wasn't missing something.

Thanks to all for your other ideas - I'm sure they all will work.

Gary
 
I've had good results with 3M Chrome Polish, but don't get it on your skin. Wear thick gloves, goggles, and use a mask. Coat it, rub it in real good (slow speed), and polish at a higher speed with a clean Viva.
 
tsp&b said:
If you just want to polish. Try Nevr-Dull. This stuff is GREAT!! http://www.nevrdull.com/ Most auto supply stores have it. Works great on any metal surface. Removes oxidation and polishes.
Click to expand...

I've been using this and also simi-chrome on my motorcycles for 40 yrs. I still have both but usually use the simi-chrome on joints. Great stuff!

Dick
 
If you have a lathe 2000 grit sand paper will do the trick. Use courser sand paper if scratches need removed and work your way down to 2000. If you do not have a lathe then the polishing compounds mentioned above are the way to go. You really don't need compounds if you have a lathe.
 
Now I hope that I never have to polish another stainless steel collar - TOOOO many options to choose from!:grin:

As always, this forum is a treasure chest of information and ideas.

Thanks again to all,

Gary
 
You must log in or register to reply here.
Back
Top