I just picked up a new McDermott Defy CF shaft with a 3/8x10 thread. I’m going to use it on my Schmelke Cue. Here’s my question..... The shaft is very tight going on the Schmelke 3/8x10 pin. I mean very tight.
I was a little hesitant putting it together the first time. I’d screw it on a little then work it back and forth. Then a little further, etc., etc. I took my time and finally got it put together fully. Should it be that tight going on? The Defy threads are plastic so will it loosen up after a while?
Any info appreciated!
Thanks
I was a little hesitant putting it together the first time. I’d screw it on a little then work it back and forth. Then a little further, etc., etc. I took my time and finally got it put together fully. Should it be that tight going on? The Defy threads are plastic so will it loosen up after a while?
Any info appreciated!
Thanks