FS: Sugartree

P

piazza

Registered
Have on hand a single-piece Curly maple plain jane Sugartree with 1 shaft, butt handsigned by Mr. Eric himself. Joint Pin customised 3-8/10, comes with solid maple shaft. Rings at B and E, alternating boxes of maple and cocobolo in between 2 gold-coloured rings. comes with black plastic joint collar and butt cap. comes with wooden joint protectors.

only to the serious buyers out there, contact me via email at meancats_chang@hotmail.com

asking 800USD with shipping

Cheers!

detail


detail


detail


detail


detail


detail


detail
 
Last edited:
I jumped all over this post, seeing that I was the first to respond, and I would pay a reasonable price, but I don't know what it's worth, so I can't make an offer. I need a price:confused: ...Tom
 
Last edited:
"pictures in a few days time" - You have got to be kidding, anything good around here at a fair price is gone before my monitor refreshes.
 
guess I better say something

Steve R said:
"pictures in a few days time" - You have got to be kidding, anything good around here at a fair price is gone before my monitor refreshes.
Click to expand...
I asked for a price three posts ago, by email as the seller requested. Laffin at "gone before the monitor refreshes" :D ... I know what ya mean ....:rolleyes:
 
i doubt very seriously it will be a fair pric.after the last sneaky pete Sugartree went for $1000 here,the Sugartree market is officially out of control.
 
well that sneaky had 3 shafts. which had something to do with its 975 price tag. this only has 1 shaft so it shouldnt be more than that.
 
The Sugartree sneaky that I offered on here a couple of weeks back went in 8 minutes. The cues are simply HOT right now.
Joe
 
Bamacues said:
The Sugartree sneaky that I offered on here a couple of weeks back went in 8 minutes. The cues are simply HOT right now.
Joe
Click to expand...

Where did you get that one at? ;)
 
masonh said:
i figure 1 shaft=125 extra.$850 still outrageous for a sneaky pete.
Click to expand...


The quality of those shafts will run you at least 200-250$ each. 125$ can get you a production shaft. Not an old growth straight grain with 15+gpi and matching ringwork.

Vic
 
you are a sucker if you are paying $250 for 15+ ppi shafts.i will get you as many as you want for $175,you name the taper.that way you will svae 450 per shaft.
 
Yes can make turn out as many $175 shaft if you want. But if supply exceed demand, you won't get that price.

You can't compare makers. I can get a Southwest for $2000++. Will it be the same as getting the design and spec from Taiwan Southwest copied cue for $200?

Sorry for hijacking this thread.
 
You must log in or register to reply here.
Back
Top