HAMMERHEAD Give away.... Outsville.....
- Thread starter The Renfro
- Start date
I'm ready to play the game.
game
I'm ready to play the game!
I'm ready to play the game!
Hi Chris,
I may not be one from which you would want feedback at 61 & mostly an 8 ball player that breaks from the side rail.
Anyway, I have two break/jump cues, one with a Picone White Diamond that I put on looking for more power while trying to keep control & one with a hard Talisman.
I like the Talisman better as I hit my break shots with low outside english. The Picone tip is a miscue waiting to happen & hence I don't go as far from center as I would like. The Talisman allows that but does not have the energy transfer that the Picone does.
Best 2 You & Good Luck with the New Products.
Rick
I may not be one from which you would want feedback at 61 & mostly an 8 ball player that breaks from the side rail.
Anyway, I have two break/jump cues, one with a Picone White Diamond that I put on looking for more power while trying to keep control & one with a hard Talisman.
I like the Talisman better as I hit my break shots with low outside english. The Picone tip is a miscue waiting to happen & hence I don't go as far from center as I would like. The Talisman allows that but does not have the energy transfer that the Picone does.
Best 2 You & Good Luck with the New Products.
Rick
Was wanting to get Russ' Opinion but they were still in the grease when I left... Daniel seemed to be thumping them pretty good with it....
Can't see any reason you wouldn't be perfect if you get drawn... Not everyone crushes the balls at 25mph.. Be interesting in what the control is like for someone breaking at a little less pace....
Ready to crackem!
Feedback
I would love to test one! Thanks for the oppurtunity.
I would love to test one! Thanks for the oppurtunity.
Just got my hammerhead tip. I have the special super glue here to install it. Not sure if I want to give them to my cue guy to install or just install it myself, because of the 24hr full cure time on the glue. Some how cutting down a sythetic tip without a lathe might be a nasty time.
Might intall it, keep a clamp on it for 24hrs then give it cue guy to turn down.
Might intall it, keep a clamp on it for 24hrs then give it cue guy to turn down.
24hrs is for full cure... It's good to go after about 5 minutes set time before the installer cuts it then it can go straight to the table and put into action.....
Last edited:
1 hour until I do the drawing....... Last chance.... May not be midnight on the Money but I will post that I am drawing when I am ready and anyone after that is out of luck until next time.....
Cutting off here.... Will post the winners tomorrow... Have consulting to do in the morning so am already up too late....