I know what I want it to look like. I dont want anything fancy. Cocobolo butt, curly maple handle, cocobolo forearm. Rings done at the top and bottom...and the top and bottom of the curly maple handle. Im not wanting to spend over 400. Think that is possible?
I think i want a custom cue...
- Thread starter Speakeasy
- Start date
I would contact (ratcues) Ryan Theewan of Mueller Recreational Products. I am sure he can help stay very close to your budget. He offers the best bang for the buck imho.
Here is the link to his page:
http://forums.azbilliards.com/member.php?u=8783
Welcome to the forum...
Good Luck in your search,
Chris
TNT cue for you no waiting.
I have this just done out of the TNT shop. It is as close as you can get to what you are looking for with no waiting. $300.00 delivered gets you this cue.
TNT Cue
1 shaft.
13.24 mm tip with a Kamui tip installed.
Shaft weighs 4.30 oz..
Butt weighs 14.10 oz..
Total weight 18.40 oz..
Radial flat faced joint with black G10 pin.
I have this just done out of the TNT shop. It is as close as you can get to what you are looking for with no waiting. $300.00 delivered gets you this cue.
TNT Cue
1 shaft.
13.24 mm tip with a Kamui tip installed.
Shaft weighs 4.30 oz..
Butt weighs 14.10 oz..
Total weight 18.40 oz..
Radial flat faced joint with black G10 pin.
Alright now that's just sick! Did you pull that out of the arse or rub the genie bottle? 15 minutes after the guy posts you slapped one together.....
Unless I cannot understand the english language this would be the cue I pictured when I read the OP's description.....except this one is a little prettier than I pictured and $100.00 cheaper!
Nice job Troy!!! :thumbup:
Last edited:
For 400 there is a lot of custom cuemakers that could make that, and it would be just as you'd want it , pin weight shaft taper joint, mike erwin made me one like that for 350, and I seen a Jacoby on here a couple months ago for that price, both great cuemakers.
Damn that was fast. hahaha I wasnt expecting something that fast. That almost what im looking for. Thats an awesome looking cue.
300 shipped and ill make you a cue like that in about 4-5 weeks
for 350 ill do it with 2 shafts.
lemme know
Marleycustomcues@yahoo.com
for 350 ill do it with 2 shafts.
lemme know
Marleycustomcues@yahoo.com
Look up Jim Pierce cues. Piercecustomcues.com. Awesome work, good person to deal with, and builds to your specs.
He said he doesn't want to spend over $400....