lathe & taper bars

That's about 6 shades of badass. Timing sucks though. I'm not coming through Indiana until Sept./Oct. time frame. Even then i'll be pulling my sawmill & not a trailer. Still yet if this don't sell right away i'm gonna figure out a way to own it.
 
Very nice!!!!

DATUM CUE said:
Sheldon metal lathe $2500. 1.375 thru hole,1.5 hp motor 3 phase,3 jaw buck chuck,5C collet closer and one .5 collet,Aloris AxA qctp and 1 holder,extended live center,Kress router holder & dust box(no router).The lathe is already set up for Deco cue taper bars,but are not on lathe because I sold that set.I will provide a set as so as I get them completed in late April.Pictures show taper bars that you will get.I prefer pickup here (zip 46056) or Indianapolis (46219 )

tomhassos@gmail.com

View attachment 177467

View attachment 177468

View attachment 177469

View attachment 177470
Click to expand...
 
now this is the machine to buy if your getting started nothing like a real lathe!!

what a nice setup.
 
Sheldon lathes are great machines. Learned on one not much unlike that one when I was a kid.
 
qbilder said:
That's about 6 shades of badass. Timing sucks though. I'm not coming through Indiana until Sept./Oct. time frame. Even then i'll be pulling my sawmill & not a trailer. Still yet if this don't sell right away i'm gonna figure out a way to own it.
Click to expand...

Hey Eric I'm in Indiana and sent you a email bout the lathe.
 
Last edited:
You must log in or register to reply here.
Back
Top