LTB Jacoby Hustler Cue
- Thread starter str8shot
- Start date
I have a beautiful Jacoby for sale here: http://forums.azbilliards.com/showthread.php?t=228645
Sorry man that is a great looking Jacoby but I have a great looking one as well I am looking for a backup cue now that is why I am looking at just a standard hustler.
Yeah I talked to him already he doesn't have a cocobolo one though I am real set on that type of wood....worst case scenario I will order a brand new one from Jacoby. I am just looking to get one cheaper than that.
I'm sorry, I didn't mean to run your sales thread, I quoted the wrong window. Great looking cue. Good luck on it. Rod.
PM sent....
This is how I roll. Check out my sig line. My Hustler hits as good as my higher $$$ Jacoby's. GL finding one!!!
Maniac
Haha that's funny I am shooting with a J4 with a OB2 and I have a pre cat predator shaft that I could put on a hustler, if I find that one with a 5/16-14 pin. Even funnier I break with a McDermott stinger with a Samsara break tip on it too, I know its not a Jerico but it still breaks a ton. I hope I can find one too thanks.
Last edited:
Lol that is what I am shooting with now.....I seen that I thought about it but I still just want a hustler though.
LOL - I tried, looked like a really good deal.
I almost (read as SHOULD HAVE) picked up a full splice sneaky from Dave at the Derby....it was/is Ebony into purpleheart. I'm afraid I'd like it more than my current Jacoby (since I like wrapless cues), and then have to have a hybrid shaft made for it as well, and well, spend MUCH more money than one should on a backup.
LOL - I tried, looked like a really good deal.
I almost (read as SHOULD HAVE) picked up a full splice sneaky from Dave at the Derby....it was/is Ebony into purpleheart. I'm afraid I'd like it more than my current Jacoby (since I like wrapless cues), and then have to have a hybrid shaft made for it as well, and well, spend MUCH more money than one should on a backup.
I know the feeling i think I am going to go back to standard maple shafts but get them turned down to the diameter that I like more,12mm.