Need help! making a Jump break cue PLEASE!!!!

[PoorBoy B]

I have made a three jump break cues one good two bad . My problem is at he joint where the fore arm meets the handle area it?s off center. Can some one tell me the process for this?

Thanks!

 

[JBCustomCues]

Check to see if your tailstock in aligned with your chuck... But what your supost to do is center drill, drill with a undersized bit, and then bore out the remainder to the apropriate size then tap for your threads.. What kind of lathe are you using would also be helpfull..

 

[Sheldon]

Your forearm and handle must be spinning dead true when you bore the holes for the threads and the pin. Without knowing what you are using to do this, any advice will be mostly guesswork.

 

[JoeyInCali]

Dial indicator does wonders.

 

[masonh]

hole could be off center or you might not have it flat faced properly.

 

[BLACKHEARTCUES]

I sent you a PM...JER

 

[manwon]

I have made a three jump break cues one good two bad . My problem is at he joint where the fore arm meets the handle area it?s off center. Can some one tell me the process for this?

Thanks!

If you find that you holes are currently off center, core them out over sized put in dowels and retapp them.