New cue ball case!!!
- Thread starter nsafellow
- Start date
Its a nice case to hold the cue ball but I have one main fault with it. The small fabric loop holding the carabiner to the case is not stable and sturdy at all. Lost my case when it was attached and was left with the carabiner and fabric. So I've lost my measle ball and have a broken ball case.
Had that same problem... Pretty disappointed... Esp since i lost my ball n yet to replace it
Just FYI, according to the comments on Amazon, the manufacturer has reinforced the loop in more recent runs of the Ballsak and supposedly corrected that issue.
Maybe the solution i to distribute the weight's focal point.
Make the loop wider.....3/8" or 1/2" or 3/4" wide and make the bottom of the clasp more flat.
The loop would distribute the weight pull across the bottom straight portion akin to a sleeve.
The case would still retain its movement since the top curved portion would remain unchanged.
Distributing the pulling action of the weighted case this way would be a much more sturdier design.
I also bought this case as a gift and the same thing happened to the person I gave the case to.
Fortunately, I transport my pool balls to the parlor in an Aramith Travel Case that holds 2 cue balls.
Matt B.
Make the loop wider.....3/8" or 1/2" or 3/4" wide and make the bottom of the clasp more flat.
The loop would distribute the weight pull across the bottom straight portion akin to a sleeve.
The case would still retain its movement since the top curved portion would remain unchanged.
Distributing the pulling action of the weighted case this way would be a much more sturdier design.
I also bought this case as a gift and the same thing happened to the person I gave the case to.
Fortunately, I transport my pool balls to the parlor in an Aramith Travel Case that holds 2 cue balls.
Matt B.
Last edited:
I have mine attached to my case , where my cues go , my cue ball goes .