pete tonkin jig AA+++++++++++
- Thread starter leon sly
- Start date
the fixture is for cutting the veneers on a 45 and also to true up the point stock this style jig is made for use on a milling machine.
http://forums.azbilliards.com/showthread.php?t=101367&highlight=milling+machine
Lets see that jig in action Leon.
Pete does make some nice goodies thats fer sure.
Pete does make some nice goodies thats fer sure.
Live or youtube:wink:
Thanks for the link to the introduction.
Looks like a great setup. I was playing with the idea of making a horizontal
clamp board with a opening in the center.
Then the CNC could precisely run a 90´ V mill down and make the cut.
But I guess this setup would be better since you have more cutting edges
to do the job.
Nice.
Kent
Looks like a great setup. I was playing with the idea of making a horizontal
clamp board with a opening in the center.
Then the CNC could precisely run a 90´ V mill down and make the cut.
But I guess this setup would be better since you have more cutting edges
to do the job.
Nice.
Kent
RBC
Deceased
Kent,
The 90 deg V cutter for a router doesn't cut very well. There are no cutting edges right at the point of the cutter. The only way to get the clean bottom is to use a bladed type cutter.
Of course, with this jig you don't use the point of the bit as you are only cutting one side of the miter.
Royce Bunnell
www.obcues.com
The 90 deg V cutter for a router doesn't cut very well. There are no cutting edges right at the point of the cutter. The only way to get the clean bottom is to use a bladed type cutter.
Of course, with this jig you don't use the point of the bit as you are only cutting one side of the miter.
Royce Bunnell
www.obcues.com
Hi Royce,
I think you are spot on in your analysis, it was just an idea I had. Actually I can't
remember how my 90´ cutter looked like (reg. edge down to the tip or not).
I'll do some more drawings on some other ideas and see if I could come up
with something.
The attached pic was just something I came over in the hugh world of tools,
but I guess that is no good since it's 91´...
Kent
Attachments
It doesn't matter man, let's see a Leon Sly Video! I think you could do a great job! Nice score, BTW.
Not bad for a meatball and garlic bread eatin mofo! That setup looks sweet dude.....
update on petes veneer jig the miter work is very nice i'm very happy with the out come.
That's some nice tight seams. Should look great in a cue.
