Push Foul Explanation

“Assuming any reasonable tip curvature”, the edge of your tip cannot touch the ball before passing the miscue limit - if it does your tip is too flat, prone to miscue and can’t produce maximum spin. Tips of any size need at least 60 degrees of arc to prevent that.

It’s the curvature, not the size (seems like I’ve heard that before).

pj
chgo

P.S. Your tip must be just about completely flat for its edge to contact the center of the cue ball as in your pic. Only good for center ball hits.
If you used a smaller tip you might realize there’s no difference except less squirt and greater visibility.

pj
chgo

Just for clarity edge at the centerline.
 
I had a follow up question to the “push” ball encounter.
Is it likely that the cue tip, moving in an upward motion after the hit, can brush the cue ball a second time?
I constantly tell myself to keep the tip on the same plane, especially if I’m trying to draw or follow.
I hate to call that kind of stuff, but it irks me.
 
I had a follow up question to the “push” ball encounter.
Is it likely that the cue tip, moving in an upward motion after the hit, can brush the cue ball a second time?
I constantly tell myself to keep the tip on the same plane, especially if I’m trying to draw or follow.
I hate to call that kind of stuff, but it irks me.
Dr. Dave established that it does in fact happen and will leave a strobed trail of chalk marks.
 
Back
Top