SugarTree Joint Size

[CueCaps]

Hello AZ'ers,
Please, I need help Again.
1. I'm making a SugarTree Cap and I need Eric's Joint Diameter for his 3/8" x 10 Thread cues.. Does anybody have one and can tell me his Joint Diameter?

2. Do you think the Standard 3/8" x 10 "V" Thread pin would fit in his shafts with the Flat Internal Thread?

3. I went to Atlas, Prather's and Lee's Site and could not find those 3/8" x 10 Flat Thread Style Pins. I tried the "Search" feature,but, didn't find anything. Anybody knows where I can get them?
Thanks for your time Guys (and Girls) ...
Alton

Thanks for the research Willee,
I just attached this Photo of Hayden's SugarTree Joint Pin after your Post below..

:thumbup: Thanks Guys,
Yes, I saw the G-10 Full Size Joint Pin at Prathers. I just wanted the JP size pins for the shaft side caps..
Thanks for the reply Eric.
Thanks for the Joint Diameter RoyL...
And Thanks Mason... Alton.

 

[WilleeCue]

Here ia a photo of a Sugar Tree cue that was posted.
By the photo it looks like a standard 3/8 x 10 joint pin.

 

[qbilder]

Alton, the normal v-groove 3/8-10 joint system will work fine. I use a standard 3/8-10 tap for my joints. My pins are 1.25" long. Hope this helps

 

[Retail1LO]

I appreciate everyone's help on this thread.

Special thanks to Eric for the fabulous cue, and to Alton for putting the finishing touches on it. You two are wonderful to work with.

-Hayden

 

[RoyL]

The joint I have measures-- .855".

 

[masonh]

like Eric said the regular 3/8-10 will work,but both atlas and Prather have the flat thread 3/8-10.

 

[qbilder]

The joint I have measures-- .855".

Yeah, that's about right. Each cue is a little different due to finish thickness until I get my new set of arbors in, but .855" is pretty much spot on.