If it's a Viking QR pin, the nut trick won't work.
The aligning portion at the front of the pin is larger than the minor diameter of the 5/16x18 nut's thread. The nut won't get past it.
I'm pretty sure that OB makes a shaft for your cue. I suggest that you inquire.
To any CM that's not aware of how to accommodate the Viking pin, the answer is quite simple.
The 5/16x18 thrd. insert is drilled with a 17/64" drill-bit, either before or after installation. This opens the min. dia. of the insert's thrds. to clear the aligning portion and still leaves adequate threads to make a secure connection with the threads at the base of the pin. I've done it 100s of times.
From last post 2009 to now.I have found that the best cure is to have a cue smith, like me, shave off a little of the unthreaded part (to the first thread)) of the QC/QR joint to the diameter of a standard 5/16 X 18 pin. This should be relatively inexpensive to shave, sand, and polish. This way it will work in any standard 5/16 X 18 or 5/16 X 18 QC/QR shaft. For more info, visit www.CustomizedPoolCues.com and contact Michael. I will be doing that to a $1550,00 cue when it arrives to fit a Hybrid Carbon Fiber Shaft I made - the low deflection of Predator Revo and the wood feel of Cuetec Cynergy with the customer's choice of tip ($349.00). See Specials on website