Who Makes a Great Standard Maple Shaft For a Decent Price?

[DJKeys]

-r-

I'm in need of a standard maple shaft. I don't like any of the high tech low-deflection shafts. I'm looking for someone who can make me a high-quality maple shaft with matching ringwork for a decent price. Any suggestions? Should I just find an old house cue that's straight and have a cuemaker chop it in half?

Jerry makes a killer shaft, 4 oz or more, very reasonable.

 

[Big Perm]

I can. $90 with matching ringwork, diameter, taper, ferrule, and tip of your choice. Straight grain, hard rock, maple.

I have owned a couple of ratcues - the quality is first rate, both with the shafts and cues themselves....

 

[Getnbzy]

I would try Bryan Mordt of BCM cues. His website:

http://www.bcmcue.com/

I believe his prices are reasonable and I think he could build you a quality maple shaft. I've had him do some work for me on my Tad and I would trust him to give you a quality shaft. He posts on here as "BryanMordt".

Ray

I second this. Bryan does outstanding work. I trust him with every cue in my sig......if that tells you anything. :thumbup:

 

[tpdtom]

Josey / Diveney / Dayton / Putnam There are many great cue makers that are turning out some very nice playing shafts . I personally have heard a ton of good things about Paul Dayton shafts and had a chance to play with a few and the hype of Dayton shafts lived up to my expectations .

Hope this helps :smile:

Larry

I agree wholeheartedly with Larry. Paul Dayton's shafts and taper are the nutz...Tom