Who wants to make this cue?

[poolrod]

I have a dream. Hoppe style. Ivory dots with lines for the Hoppe ring in all positions. .300 wide dot on the bottom diameter, .175 to .200 dot diameter on the rest. The trim ring will look like the Ginacue in the pic. I would like the cue to be ebony butt, very light maple forearm, 6 high and low ebony points.
Two natural veneers inside the points. Black, very thin irish linen wrap. 19oz, and two shafts. 58" 13mm shafts. solid ivory joint. The design is just a rough draft.Thank you. Rod.

I found a maker, thank you all.

Design.

Forearm Design just like this.

Trim Ring Design.

 

[cuesblues]

I've never made a cue before but I would be willing to give it a try.
Once I get some equipment and figure out how to use it we can talk deposit.

 

[CMD]

I've never made a cue before but I would be willing to give it a try.
Once I get some equipment and figure out how to use it we can talk deposit.

I think what my colleague meant to say this may have been posted in the wrong section. Try " Ask the Cuemaker".


Good Luck,
Chris




Sent from my iPhone using Tapatalk

 

[cuesblues]

I think what my colleague meant to say this may have been posted in the wrong section. Try " Ask the Cuemaker".


Good Luck,
Chris




Sent from my iPhone using Tapatalk

I don't think we need to get carried away and involve any cuemaker's.
If I can't figure it out, I will commision 2-unknown cuemakers as project consultants.

 

[measureman]

I don't think we need to get carried away and involve any cuemaker's.
If I can't figure it out, I will commision 2-unknown cuemakers as project consultants.

Two unknown cue makers? How about Fong Chen and Ling Chou from the Lucasi factory? They have been taught by Bill Stroud.
They also secretly make cues called "Unified Cues".