Why would I choose Gecko?

[Mc2]

I have used the Gecko 540 controller on all of my cnc projects over the past couple of years for several reasons. They make one of the best 4 axis controllers in its class. Recently I had one of the individual amps go bad in one. This is not normal. I opened up the controller (not hard to do) and noticed that the amp had a few burnt parts on it. When I spoke with Gecko, they informed me that I should just send back the amp. with their on-line return form printed out. They will check it out, repair it, and send it back to me for free. This is customer service. Well I ordered a new amp to get me by (one of the four in the G540) until the repaired one comes back. When I received the box I found an additional surprise.

Jim.

 

[ScottR]

I have used the Gecko 540 controller on all of my cnc projects over the past couple of years for several reasons. They make one of the best 4 axis controllers in its class. Recently I had one of the individual amps go bad in one. This is not normal. I opened up the controller (not hard to do) and noticed that the amp had a few burnt parts on it. When I spoke with Gecko, they informed me that I should just send back the amp. with their on-line return form printed out. They will check it out, repair it, and send it back to me for free. This is customer service. Well I ordered a new amp to get me by (one of the four in the G540) until the repaired one comes back. When I received the box I found an additional surprise.

Jim.

I don't see the parallel port.

Scott

 

[Mc2]

It is there

Scott you have to turn it over to see the port. LOL

Jim

 

[JoeyInCali]

Thanks for sharing after I bought SighSlowtex.:grin-square:

 

[GBCues]

Sweet!! A new shop pet!!

 

[RBC]

Cool!

It looks like it would go with that cue you have!

You know, the one that looks allot like that Gecko LOL@