WTB cue lathe

New Guy welcome to the board and her is a little bump for you
I have bin looking for a wile as well
good luck to you and your search
Thanks Chris
 
Thanks for the replies

Looked at the harbor freight lathe and is great for the $$. The thing I cannot find is a hole through the spool larger than 3/4" and 5/8" chuck. If I could find a way to increase the hole in the spool to 1 1/2" to accomodate the butt, I could face joints. I only need it for tips, ferrules and facing joints. I have no interest in building cues, but I own a room and it would be convenient to do minor repairs mainly as customer service. Hence, I am not interested in either a large machine or spending a lot of $$.
 
Thanks Willee

The cue companion just came on. Think I would like something a little more accurate for re-facing joints, but thanks for the lead
 
dirtydog48 said:
The cue companion just came on. Think I would like something a little more accurate for re-facing joints, but thanks for the lead

Actually, the Unique CueCompanion is very accurate for facing joints and such. It uses a collet type chuck and a tail stock to hold the Shaft / Butt.

I doubt you will ever find a used CueCompanion for less than $1000 but it is exactly what you need for what you are wanting to do. IMHO
 
I Have 2 Cue Companions That I Would Part With.

What You Want With Them Will Determine Pricing. Just The Lathes Will Start At 950 Shipped.
 
dirtydog48 said:
The cue companion just came on. Think I would like something a little more accurate for re-facing joints, but thanks for the lead

For what you are wanting to do, and the price range you're looking at, I think the only route you CAN go is the Harbor Freight Lathe. You will also need 2 steady rests. One for the lathe bed (to face the joints), and one for the table beside the lathe to steady the back of a shaft when you are replacing the tip or ferrule.

Lathe:
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=93212

Bed Steady Rest:
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=43579

1 example of stand alone steady rest, you can search the forums here for more examples:
http://cgi.ebay.com/PRO-LATHE-ROLLE...VQQcmdZViewItemQQ_trksidZp1638Q2em118Q2el1247
 
Thanks Shakes

But I still would like to put the shaft and but thru the spindle and that would require about 1 1/2" hole in the spindle. Then I could mount a rest behind the spindle but would still need a slide on the opposite side from the chuck.
Thanks for the info.
 
dirtydog48 said:
But I still would like to put the shaft and but thru the spindle and that would require about 1 1/2" hole in the spindle. Then I could mount a rest behind the spindle but would still need a slide on the opposite side from the chuck.
Thanks for the info.

there isnt a lathe availible anywhere near your price for what you want. the cheapest you can go it with a midsize cuesmith lathe and upgraded headstock for like 2K$.

dont want to be rude but u have no chance in hell finding what you are looking for.

the cheapest lathe you can get to do what you want is the cuesmith
microII. the thru hole is only like 5/8 but it has a steady rest and collet system that you can tap shafts and insert pins ect

it starts at 850$ with no tooling taps bits ect. shipping will be like 100$

you are specding 1200$ minimum no matter what
 
Back
Top