WTB: South West Spare Shaft!

J

JayTS

Certified Donator
Silver Member
Just as the title says i'm looking for one or two spare South West shafts. I'd like them to be anything around 12.5mm. Thanks -J
 
Last edited:
SW Shaft

I've got one SW shaft with some taper roll in it (dime's width +-) that I'd part with for $175 shipped. It's 13 mm at the tip and 3.65 oz.
 

Attachments

  • sw joint.JPG
    sw joint.JPG
    19.2 KB · Views: 648
first page for the night crew! I know someone has to have one of these laying around...
 
sw shaft

I have one sitting around for at least 25 years, I'll check the straightness, and diameter. And if it's good, it's yours for $80 + shipping.
Ok, I got home and checked it out. It is 13.462 diameter with a yellow micarta ferrule. The trim ring is .820 diameter. The shaft has a very slight warp to it, and needs a serious cleaning. It rolls straight on the cue.
If you have it turned down to a 13mm, the warp might be gone. It would be fine for a back up shaft with a professional cleaning and a new tip.

My camera lies, it doesn't look this bright. LOL. Rod.
DSCF1010.jpg

DSCF1011.jpg

DSCF1009.jpg

DSCF1008.jpg
 
Last edited:
Dang I missed out on that one.. That's the problem with this forum it's not easy enough to check out your subscribed threads to know if someone replied or not. Bump it!
 
I have one 12.9mm southwest shaft that has basically no play on it for sale. I can post a picture if you are interested.
 
You must log in or register to reply here.
Back
Top