................................

seven_7days said:
looks like 3/8x10 piloted
Click to expand...

runout1961 said:
I was thinking that could possibly be it as well but have never seen one.
Click to expand...

I think it is just an extra good picture....I think my Richard Black shafts will fit right on...
....they are 14 thread.

As an aside....what kind of joint is this? :eek:

image.jpeg
 
Your tool here is perspective. The jnt collar is 1" long. It's .840" wide.
If you were to continue the thread count for a full inch, the length of the jnt. collar,
you'd be looking at a 14 tpi pin. How many piloted 3/8x10 pins have you actually seen ?
 
KJ Cues said:
Your tool here is perspective. The jnt collar is 1" long. It's .840" wide.
If you were to continue the thread count for a full inch, the length of the jnt. collar,
you'd be looking at a 14 tpi pin. How many piloted 3/8x10 pins have you actually seen ?
Click to expand...

I counted the threads and used the joint collar reference for one inch. I came up with ten.

I have only rarely seen one...but I do believe this is one.

EDIT: Just tried it again. Still got ten. Downloaded it to image software to double check. Still got ten.

Maybe I am crazy?

.
 
You may be correct.
Attributing percentages to the 'knowns' puts the pin at or close to 3/8" dia.
Doing the same to thread count put me above 10 but it could be the angle of the pic.
I also have seen a piloted 10 but haven't fully grasped the concept. Why ?
 
It would seem a good way to crack a pilot, no? Not a lot of meat there and any lateral stress before it is screwed down would seem likely to crack it.


I have no idea of the reasoning. Many people have opinions about how different joints play and maybe they were looking for some ethereal quality of feel? Hard to say.

I like a piloted 14 joint. Old school. It works.



.
 
Isn't the Lambros Ultra Joint basically a piloted 3/8X10 pin? With modifications of course but at least from what I've seen (as I've never owned nor held one) it APPEARS to be some sort of 3/8X??? pin....... The pilot and joint collar seem a bit small/thick (pilot/joint collar) to be a 3/8 x anything...... I would honestly guess more along the lines of 5/16X14 or something along those lines based solely on what can be seen and the guessed dimensions i.e. inner diameter of the collar/pilot..... I could be VERY VERY wrong of course. But just figured I'd throw my hat in here lol.
 
You must log in or register to reply here.
Back
Top