Thanks, I'll find my tape. It's a custom bob Thompson one off.
Rhino CF shafts....159bux, free ship
- Thread starter garczar
- Start date
i just Googled his cues. looks like all are 3/8x10.
Thank you. I thought that I recalled that was the case, but need to be sure before I gamble $170 , effectively betting my marriage, lololol.
I dun did it....bet placed on the break shaft with 3/8 10. I may need to dodge some flying plates soon ..
Got mine on Thursday. Put the shaft on my Meucci and it screws on flush but is just a hair bigger than the butt. Played for about an hour with it and liked it fine, although it is lighter than my wood
If I can get over the very slight oversized does anyone see any reason not to keep it such as damaging the butt or shaft.
If I can get over the very slight oversized does anyone see any reason not to keep it such as damaging the butt or shaft.
Mine was a tad smaller but its really close. not enuff to sweat.
BlueRaider
Registered
Astroturfed or not, this is some great viral marketing. I bought a 12.5mm with the medium tip for my Meucci butt. Hope it fits well. My OB Classic+ fits perfectly but the slight warp it developed + my curiosity about carbon fiber led me here.
Blame it on me, i posted the first link to the sale. Think of Steppenwolf's 'The Pusher'
I said gawdam. GaaaAwdamn the gaczaman.Blame it on me, i posted the first link to the sale. Think of Steppenwolf's 'The Pusher'
I went back in. Got a $255 pool cue to leave in the car and I can put either the pool or carom shaft on it.
boogieman
It don't mean a thing if it ain't got that ping.
I hit with one about 3-4 years ago. I'm not sure what kind it was but I didn't like it at all. A guy I played at a tournament let me try it out back then. To me it felt whippy but that's a long time to remember for me.
I've tried quite a few cf shafts and not one was remotely 'whippy'. All were pretty damn stiff to be honest. No clue what you tried. sounds like a cheap cf sleeved over wood pos.
Last edited:
If the thread sizes do not match up (too tight/loose), would that be considered a defective or a non-defective product??? Just curious.
In contractual/ policy/ legalese type language, it should also be defined by whom a determination will be made.
Your guess is as good as mine on that one, you maniac!.
That said, presuming the joint snugs up appropriately when screwed fully, it should be good, no? If is isn't tight then, that would not be an acceptable fit.
Adding this here from the other Rhino thread. I contacted Rhino asking if their shafts are made in Vietnam or China. They answered proudly Vietnam.
That poor Celine.
I been working her over via email myself.
She (if she is a real singular person) is a fine representative for Rhino. Thumbs UP
Mine screws on my Mezz very snug. Last few turns take some effort but not bad. Rather have this than have it come loose every few shots.