bludworth pin size

ok

its 3/8 11.37 sorry i wasnt exact.... ive only owned 3 and had pred shafts made for all of them but what do i know
 
masonh said:
i always though it was 3/8-11.5.
Click to expand...
I thought it was like .345 .
You need his tap not the usual 3/8 11.
Blud has always said 3/8 is too stiff.
 
turbo billards said:
its 3/8 11.37 sorry i wasnt exact.... ive only owned 3 and had pred shafts made for all of them but what do i know
Click to expand...
Not too sure why you're getting somewhat huffy about this but Joey's right to try and answer this question with a dead nuts accurate number. It makes a difference in how it fits.

Gene
 
Dawgie said:
What is the pin size for a Buldworth cue? I want to get a Z/2 shaft for my cue.
Click to expand...

I've always refered to it as a 3/8-11.5 and I have the compression tap to make that shaft, if you are interested. Very nice tight fit. Blud was ahead of the curve with that pin. Similar to the radial fit without the mass.
 
i see Gene's point,no reason to be sarcastic b/c whatever it is it definitely isn't a 3/8-11.i have one in the shop and i will mic it tomorrow.
 
Tommy-D said:
> I just looked back thru my old PM's,and Blud himself said the pin is .348 x 11.445. Tommy D.
Click to expand...
I just miced one and Tommy-D is on the money. .348

Gene
 
JoeyInCali said:
ding ding ding, we have a winner.
Click to expand...
Howdy, had received an e-mail from Blud that told me the same sizes back in March. Before that I had a local Cue maker/repairman build 2 shafts for me, used a 3/8" x 11.5 tap for the shafts. start out abit loose but snug-up real tight. Haven't had any problems.
 
You must log in or register to reply here.
Back
Top