I have a true "old-school" wrapless Titless conversion by Mike Webb available. This cue has an ivory ferrule and Hoppe ring and is finished off with the no-bumper/polished weight-bolt look for the true old style look. It is a really sweet looking cue, and it plays great, too. It is in exceptional condition with only a couple of extremely light surface bumps and a little shaft bluing. It is a great conversion from a super cuemaker. Cue is straight, together and apart.
Specifications:
-Butt: 14.1 ounces, 29", bumperless
-Shaft: 3.9 ounces, 29", 12.95mm, Ivory ferrule, unsure of tip
-19" balance point
-5/16x14 piloted stainless steel joint
-Black phenolic joint collars with maple rings and dashes
-Body of the cue is a very nice Titlist...I think it is either mahoghany or rosewood...always tough to tell with these old cues. The Titlist veneers of natural, mahoghany, green and purple are bright and almost dead-nuts even.
-Ivory Hoppe ring with "Webb" logo
-Black phenolic butt cap
-Polished weight bolt
-Custom JPs included
-Joint: 0.843"
-1" above butt cap: 1.235"
-Butt cap: 1.250"
SOLD, pending receipt of payment
Joe
[/IMG]
Specifications:
-Butt: 14.1 ounces, 29", bumperless
-Shaft: 3.9 ounces, 29", 12.95mm, Ivory ferrule, unsure of tip
-19" balance point
-5/16x14 piloted stainless steel joint
-Black phenolic joint collars with maple rings and dashes
-Body of the cue is a very nice Titlist...I think it is either mahoghany or rosewood...always tough to tell with these old cues. The Titlist veneers of natural, mahoghany, green and purple are bright and almost dead-nuts even.
-Ivory Hoppe ring with "Webb" logo
-Black phenolic butt cap
-Polished weight bolt
-Custom JPs included
-Joint: 0.843"
-1" above butt cap: 1.235"
-Butt cap: 1.250"
SOLD, pending receipt of payment
Joe
Last edited: