pin adapters

LILJOHN30

LILJOHN30

AzB Silver Member
Silver Member
I'm looking for adapters that I can screw into my shafts and then in sert into my drill to clean the shaft and other maintenance.I would need a radial pin adpter and a 3/8 x 10 g-10 pin adapter.Any ideas from the experts.
 
I don't think they would work in my hand drill,I can't fit them into the chuck..I saw a thread a while back about this topic and how some people made some home made ones.
 
They were using crutch tips the rubber peice. find ones that fit your shaft drill a hole back threw base with washers on both sides and lock together with a nut. then you can chuck up on the bolt.
 
fordtechandy said:
They were using crutch tips the rubber peice. find ones that fit your shaft drill a hole back threw base with washers on both sides and lock together with a nut. then you can chuck up on the bolt.
Click to expand...
thanks for the tip.
 
Just go to Atlas or Prather & buy one each of the pins that you need. Half into your shaft....half into your drill. ;)
Be careful or I'll charge you double to fix your errors.:D
 
LILJOHN30 said:
I'm looking for adapters that I can screw into my shafts and then in sert into my drill to clean the shaft and other maintenance.I would need a radial pin adpter and a 3/8 x 10 g-10 pin adapter.Any ideas from the experts.
Click to expand...


Check with Chris Hightower Cueman The ones he sells will fit a drill and do what you want.....

The link http://cuesmith.com/
 
just buy a pin and be careful.if you are using a drill i don't see any reason to go out and buy arbors.just chuck the pin up in the drill and try to make sure it isn't wobbling or bouncing,then screw on the shaft and spin.
 
LILJOHN30 said:
I'm looking for adapters that I can screw into my shafts and then in sert into my drill to clean the shaft and other maintenance.I would need a radial pin adpter and a 3/8 x 10 g-10 pin adapter.Any ideas from the experts.
Click to expand...

Contact the guy from ShaftMaster Lathes, he sells some small ones for his lathes. Then you could buy an adapter for your drill chuck!!!!!!
 
LILJOHN30 said:
thats what I'm looking for is there one for the radial pin also.
Click to expand...

I bought some of these to use in my spray booth. Unless he is now making radial pin he use to not carry them. It would be worth asking.
 
Hi again,

Yes, mine came with the radial pin also. I bouth them about 6 months ago. They are made out of delrin(maybe) with stainless pins.

regards,
 
You must log in or register to reply here.
Back
Top