Here is a cue I purchased awhile back with the intention of keeping, but things change and so do projects.
Little is known about this cue except that it is certainly an R-Series cue from the 1980's. It appears that the cue may be a R-12 Variant cue and it could also be 1 of 1 which many of the variant cues were. I have not had any luck as yet contacting Bob Runde about this cue so that I could gather additional information. All aside, this cue is a must for any serious Schon R-Series or Runde Series collector because you will not find another cue like this one, and also to my knowledge the cue with the exception of the shafts is Original unrestored Condition. The cues shafts have been cleaned / Sealed and new finish has been applied to the joint collars by me.
The cue come with two shafts both have Westinghouse macarta Ferrules, shaft 1 is 13mm or .310 / 29 inches long and shaft 2 is 12.5mm or .290 and it is 28 15/16 inches long.
Shaft 1 weighs - 4.1 oz
Shaft 2 weighs - 3.7 oz
Both Shafts have a very minor taper roll, but nothing that will effect playability.
The cues butt is 29 1/4 inches long and it weighs 15.7 oz, the joint diameter is .830 and the butt cap diameter is 1.245.
The Cue butt is dead straight.
Asking Price is 1000 + Shipping but reasonable offers may be excepted
On to the photo's:





If anyone would like additional information or photo's please contact me.
Merry Christmas to all!!!!!
Little is known about this cue except that it is certainly an R-Series cue from the 1980's. It appears that the cue may be a R-12 Variant cue and it could also be 1 of 1 which many of the variant cues were. I have not had any luck as yet contacting Bob Runde about this cue so that I could gather additional information. All aside, this cue is a must for any serious Schon R-Series or Runde Series collector because you will not find another cue like this one, and also to my knowledge the cue with the exception of the shafts is Original unrestored Condition. The cues shafts have been cleaned / Sealed and new finish has been applied to the joint collars by me.
The cue come with two shafts both have Westinghouse macarta Ferrules, shaft 1 is 13mm or .310 / 29 inches long and shaft 2 is 12.5mm or .290 and it is 28 15/16 inches long.
Shaft 1 weighs - 4.1 oz
Shaft 2 weighs - 3.7 oz
Both Shafts have a very minor taper roll, but nothing that will effect playability.
The cues butt is 29 1/4 inches long and it weighs 15.7 oz, the joint diameter is .830 and the butt cap diameter is 1.245.
The Cue butt is dead straight.
Asking Price is 1000 + Shipping but reasonable offers may be excepted
On to the photo's:





If anyone would like additional information or photo's please contact me.
Merry Christmas to all!!!!!

Last edited: