So Mezz has a new joint pin
- Thread starter Thunder Thighs
- Start date
Why?
I wonder if this is good news or bad news. The plethora of joint pins really limits the choices of using different shafts. I experienced this with a Mike Bender cue and I am certain others have with other pins. It remains to be seen if Mezz is now going to offer all of it's shafts with this new design..
No idea
From their site: http://mezzcue.com/en/technology_po...KBEg699A7G2RjEV1XsggGO3Us-ZjGkNTloS2f4OzHHYbE Both will fit on the new butt but the new shaft won't go on older butts. What would be the technical difference in the pins?
Last edited:
Another bastard screw. Now has longer pilot to locate the hole to properly center the screw ?
Why?
If the ID of the screw matches the hole size , you'll have no problems .
Double screw just makes the threads narrower . Does that give them more axial force ?
The first Wave screw was just a bastardized radial screw .
Why?
If the ID of the screw matches the hole size , you'll have no problems .
Double screw just makes the threads narrower . Does that give them more axial force ?
The first Wave screw was just a bastardized radial screw .
Maybe Wavy2 is three cents cheaper to manufacture.
If its longer why will the older shafts fit on the new butt? Something i'm not getting here.
Is the wavy joint the one that also fits the radial joint? I might be thinking of another joint.
It's the United joint that fits the 5/16-14
It does look shiny though!
JT4Annapolis
JT in FL now
not backwards compatible to old wavy pin not cool for those with a bunch of mezz shafts already
The older shafts will go on the new butt. Just can't put a new W2 shaft on a Wavy1 butt. I think its kinda goofy as well.
Got it. I do know (off subject) that a lot of guys have shafts threaded for both 3/8X10 and radial. That's very popular in my neck of the woods.
All about the benjamins.
